LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 237 (Rear Disc Brake System) >> Removal And Installation >> Rear Disc Brake >> Removal

Rear Disc Brake: Removal

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel and tire. For additional information, refer to WHEELS AND TIRES .
  2. NOTE: Do not allow the caliper to hang from the brake hose or damage to the hose can occur.

    Remove and discard the 2 brake caliper anchor plate bolts and position the brake caliper and anchor plate assembly aside.

    • Support the brake caliper and anchor plate assembly using mechanic's wire.
  3. Remove and discard the brake disc screw.
  4. Thread a M10 bolt into the brake disc removal hole and tighten to press the brake disc off the hub.
scientia non olet · About LEMON Manuals