LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 237 (Rear Disc Brake System) >> Removal And Installation >> Rear Disc Brake Shield >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the brake caliper anchor plate. For additional information, refer to BRAKE CALIPER ANCHOR PLATE  .
  2. Remove and discard the brake disc screw and remove the brake disc.
    • To install, tighten to 20 Nm (177 lb-in).
  3. Remove the 3 bolts and the brake disc shield.
    • To install, tighten to 15 Nm (133 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals