LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 237 (Rear Disc Brake System) >> Removal And Installation >> Rear Brake Caliper Anchor Plate >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Do not pry in the brake caliper sight hole to retract the pistons, as this can damage the pistons and boots.
NOTE: Do not allow the brake caliper to hang from the brake hose or damage to the brake hose can occur.
NOTE: Make sure the brake caliper hose is not twisted during caliper installation.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING
  2. Remove the wheel and tire. For additional information, refer to WHEELS AND TIRES .
  3. Remove and discard the brake pads. For additional information, refer to BRAKE PADS  .
  4. Remove the brake caliper anchor plate bolts and remove the brake caliper anchor plate.
    • To install, tighten to 90 Nm (66 lb-ft).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals