LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 236 (Interior Trim And Ornamentation) >> Removal And Installation >> Quarter Trim Panel

Quarter Trim Panel

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For information on Ford Color Coded Illustrations refer to COLOR-CODING - FORD .

LH side with power liftgate 

  1. Remove the power liftgate motor. For additional information, refer to BODY CLOSURES .

    All vehicles 

  2. Remove the rear door scuff plate trim panel. For additional information, refer to SCUFF PLATE TRIM PANEL - REAR  .
  3. Remove the liftgate scuff plate. For additional information, refer to INTERIOR TRIM - EXPLODED VIEW  .
  4. Remove the rear storage compartments from the spare tire well.
  5. NOTE: Inspect the safety belt lower anchor bolt cover for damage. If the safety belt lower anchor bolt cover does not remain in place, install a new cover.

    Remove the safety belt lower anchor bolt cover and remove the safety belt lower anchor bolt.

    • To install, tighten to 54 Nm (40 lb-ft).
  6. If equipped, remove the cargo net hook.
    • To install, tighten to 3 Nm (27 lb-in).
  7. NOTE: Make sure the pushpin retainers are removed with the quarter trim panel.

    Remove the RH or LH quarter trim panel.

    • Disconnect the electrical connectors, if equipped.
  8. To install, reverse the removal procedure.