LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 236 (Interior Trim And Ornamentation) >> Removal And Installation >> C-Pillar Trim Panel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: Inspect the safety belt D-ring cover for damage. If the safety belt D-ring cover does not remain in place, install a new cover.

    Remove the safety belt D-ring cover and remove the safety belt bolt.

    • To install, tighten to 54 Nm (40 lb-ft).
  2. Remove the screw cover.
  3. Remove the screw.
    • To install, tighten to 9 Nm (80 lb-in).
  4. Position the quarter trim panel aside to allow C-pillar trim panel removal.
  5. Remove the C-pillar trim panel.
    • Pull outward and downward to remove the panel.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals