LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 234 (Supplemental Restraint System) >> Removal And Installation >> Clockspring >> Removal

Removal And Installation: Clockspring: Removal

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is on.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
  1. Remove the driver air bag module. For additional information, refer to DRIVER AIRBAG  .
  2. Remove the steering wheel. For additional information, refer to STEERING COLUMN .
  3. Remove the steering column shroud. For additional information, refer to STEERING COLUMN .
  4. Disconnect the clockspring electrical connector(s).
  5. Remove the 3 clockspring screws.
  6. Remove the clockspring.
    • Pull the clockspring straight off the steering column to disconnect it and disengage the clockspring pins from the steering wheel rotation sensor pin holes.
scientia non olet · About LEMON Manuals