Normal Operation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

The Restraints Control Module (RCM) is in constant communication with various control modules on the High Speed Controller Area Network (HS-CAN). One of those modules is the Occupant Classification System Module (OCSM). The RCM continuously monitors the HS-CAN for fault messages reported by the OCSM . The RCM also checks for the correct identification of the OCSM . If the RCM receives fault message(s) from the OCSM , it stores DTC B00A0:09, B00A0:4A, B00A0:63, B00A0:64 or B00A0:68 in memory and sends a message to the Instrument Panel Cluster (IPC) to illuminate the airbag warning indicator.

This pinpoint test is intended to diagnose the following:

OCSM
RCM

DTC DESCRIPTION

DTC Description	Fault Trigger Condition
B00A0:09 - Occupant Classification System: Component Failure	A fault is indicated when the RCM receives a message from the OCSM that a fault exists within the OCS .
B00A0:4A - Occupant Classification System: Incorrect Component Installed	A fault is indicated when the RCM senses the OCSM is present but not configured.
B00A0:63 - Occupant Classification System: Circuit/Component Protection Time-Out	A fault is indicated when the RCM receives 8 or more invalid states from the OCSM .
B00A0:64 - Occupant Classification System: Signal Plausibility Failure	A fault is indicated when the RCM receives messages containing upper or lower data limits other than limits stored in memory.
B00A0:68 - Occupant Classification System: Event Information	A fault is indicated when the RCM receives a message from the OCSM containing incorrect data.