LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 234 (Supplemental Restraint System) >> Diagnosis And Testing >> Airbag and Safety Belt Pretensioner Supplemental Restraint System (SRS) >> Pinpoint Test - Restraints Control Module (RCM) >> Pinpoint Test AM: DTC U200D:12 >> Normal Operation

Normal Operation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

The OCSM  monitors each OCS  weight sensor bolt and circuitry for faults. If the OCSM  detects unwanted voltage on any weight sensor VREF circuit it stores DTC U200D:12 in memory and sends a message to the RCM  . The RCM  stores DTC B00A0:09 in memory and sends a message to the IPC to illuminate the airbag warning indicator.

DTC DESCRIPTION

DTC Description Fault Trigger Condition
U200D:12 Control Module Output Power A: Circuit Short to Battery If the OCSM  detects voltage above 5 volts on any weight sensor VREF circuit, it sets this DTC.

This pinpoint test is intended to diagnose the following: