Toe Link: Installation
WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
-
NOTE: Do not tighten the toe link outboard bolt and nut at this time.
Position the toe link and loosely install the new toe link outboard bolt and nut.
-
NOTE: Do not tighten the toe link inboard cam bolt and nut at this time.
Position the toe link adjuster cam and loosely install the new toe link inboard bolt and nut.
- Install the wheel and tire. For additional information, refer to WHEELS AND TIRES .
- With the weight of the vehicle on the wheel and tire, tighten the toe link outboard bolt and nut to 175 Nm (129 lb-ft).
- With the weight of the vehicle on the wheel and tire, tighten the toe link inboard bolt and nut to 200 Nm (148 lb-ft).
- Check and if necessary adjust rear toe. Refer to SUSPENSION SYSTEM - GENERAL INFORMATION .