LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 233 (Rear Suspension) >> Removal And Installation >> Spring >> Installation

Removal And Installation: Spring: Installation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. If removed, position a new lower seat into the lower arm with the recess in the seat aligned with the projection on the lower arm.
    Fig 1: Locating Lower Seat And Arm
    G06500659Courtesy of FORD MOTOR CO.
  2. Position the spring onto the lower arm with the end of the spring 0-10 mm (0-0.39 in) from the step on the spring seat.
    Fig 2: Identifying Position Of Spring Onto Lower Arm
    G06269499Courtesy of FORD MOTOR CO.
  3. WARNING: The coil spring is under extreme load. Care must be taken at all times when removing or installing a loaded spring. Failure to follow this instruction may result in serious personal injury.

    Using a suitable jackstand, raise the lower control arm assembly.

  4. Install the wheel knuckle. For additional information, refer to Wheel Knuckle  .