LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 232 (Front Suspension) >> Removal And Installation >> Lower Arm >> Installation

Lower Arm: Installation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: Do not tighten the bolt at this time.

    Position the lower arm and loosely install the 2 new lower arm-to-frame rearward bolts.

  2. NOTE: Do not tighten the bolts at this time.

    Loosely install the new lower arm-to-frame forward bolt and install the spacer.

  3. Install the new lower arm ball joint bolt and nut.
    • Tighten to 55 Nm (41 lb-ft).
  4. Install the new stabilizer bar link lower nut.
    • Tighten to 90 Nm (66 lb-ft).
  5. Install the wheel and tire. For additional information, refer to WHEELS AND TIRES .
  6. With the weight of the vehicle resting on the wheels and tires, tighten the lower arm-to-frame forward bolts to 150 Nm (111 lb-ft).
  7. With the weight of the vehicle resting on the wheels and tires, tighten the 2 lower arm-to-frame rearward bolts to 80 Nm (59 lb-ft).
  8. Check and, if necessary, align the front end. For additional information, refer to WHEELS AND TIRES .
scientia non olet · About LEMON Manuals