Exhaust Flexible Pipe: Removal

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Do not excessively bend, twist or allow the exhaust to hang from the flexible pipe or damage to the exhaust system may occur.

NOTE: Always install new fasteners and gaskets. Clean flange faces prior to new gasket installation to make sure of correct sealing.

NOTE: Do not use oil or grease-based lubricants on the isolators. They may cause deterioration of the rubber.

NOTE: Oil or grease-based lubricants on the isolators may cause the exhaust hanger isolator to separate from the exhaust hanger bracket during vehicle operation.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Support the muffler and tailpipe with a suitable jackstand.
Loosen the Torca® clamp retainer.
NOTE: Do not damage or tear the isolator during removal.

Using soapy water, detach the exhaust flexible pipe isolator.
Remove and discard the 2 nuts. Remove the exhaust flexible pipe.
- Discard the gasket.