Exhaust Flexible Pipe: Installation
WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The muffler and tailpipe Torca® clamp must be tightened last.
- Install the new gasket, the exhaust flexible pipe and 2 new nuts.
- Tighten to 40 Nm (30 lb-ft).
- Attach the exhaust flexible pipe isolator.
- Tighten the Torca® clamp retainer.
- Tighten to 54 Nm (40 lb-ft).
- Start the engine and check for exhaust leaks.