Catalytic Converter - RH: Removal
WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
All vehicles
-
NOTE: Always install new fasteners and gaskets. Clean flange faces prior to new gasket installation to make sure of correct sealing.
With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Remove the Catalyst Monitor Sensor (CMS). For additional information, refer to ELECTRONIC ENGINE CONTROLS .
- Remove the exhaust Y-pipe. For additional information, refer to EXHAUST Y-PIPE
.
All-Wheel Drive (AWD) vehicles
- Remove the transaxle support insulator - anti roll. For additional information, refer to AUTOMATIC TRANSMISSION - 6F50/6F55 .
- Rotate the engine forward.
All vehicles
- Remove the 4 nuts and the RH catalytic converter.
- Discard the 4 RH catalytic converter nuts and gasket.