Catalytic Converter - LH Manifold: Installation
WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
- Install 6 new LH catalytic converter manifold-to-cylinder head studs.
- Tighten to 12 Nm (106 lb-in).
- Install a new gasket, the LH catalytic converter manifold and 3 new lower LH catalytic converter manifold-to-cylinder head nuts.
- Tighten to 25 Nm (18 lb-ft).
- Install the 3 new upper LH catalytic converter manifold-to-cylinder head nuts.
- Tighten to 25 Nm (18 lb-ft).
- Install the exhaust Y-pipe. For additional information, refer to EXHAUST Y-PIPE .
- Connect the LH CMS electrical connector.
- Install the heat shield and the 3 heat shield bolts.
- Tighten to 12 Nm (106 lb-in).
- Install the LH Heated Oxygen Sensor (HO2S). For additional information, refer to ELECTRONIC ENGINE CONTROLS .
- Install the engine appearance cover. For additional information, refer to ENGINE APPEARANCE COVER - EXPLODED VIEW (3.5L) or ENGINE APPEARANCE COVER -- EXPLODED VIEW (3.7L) .
- Start the engine and check for exhaust leaks.