LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 220 (Automatic Transmission - 6F35) >> Diagnosis And Testing >> Automatic Transmission >> Diagnostic Routines >> Pinpoint Test E: P0770, P0773, P0774 >> Normal Operation and Fault Conditions

Normal Operation and Fault Conditions

WARNING: This page is about a different car, the 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

SSE  controls the multiplexing of the SSD  low/reverse and overdrive clutch. If SSE  fails off (no pressure) then 1st gear is failed to 4th gear. If clutch select valve 2 sticks in the default position then 1st gear with engine braking is failed to 4th gear and reverse is failed to neutral. SSE  is an On/Off solenoid.

DTC FAULT TRIGGER CONDITION

DTC Description Fault Trigger Conditions
P0770 SSE  Open, short to power or short to ground in the solenoid or wire harness.
P0773 SSE  Electrical Open or short to ground in the solenoid or wire harness.
P0774 SSE  Intermittent Intermittent circuit in the solenoid or wire harness open, shorted to ground or shorted to power.
scientia non olet · About LEMON Manuals