LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 219 (Automatic Transmission - 6F50/6F55) >> Removal And Installation >> Solenoid Body Assembly >> Installation

Solenoid Body Assembly: Installation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: Make sure not to pinch the TSS  , OSS  or TR  sensor wiring harnesses behind the solenoid body when positioning the solenoid body in place.

    Hand-tighten only.

    1. 42 mm (1.653 in) bolt
    2. 63 mm (2.48 in) bolts
    3. 80 mm (3.149 in) bolts
    4. 95 mm (3.74 in) bolts
      G08412416
    • Tighten to 12 Nm (106 lb-in).
      G08412417
  3. G08412418
  4. G08412411
  5. Connect the TR  sensor electrical connector and slide the lock tab to the LOCK position.
    G08412420
  6. Install the main control cover. Refer to MAIN CONTROL COVER .
  7. Wipe the surface of the existing solenoid body strategy tag on top of the transmission case clean and install the new solenoid body strategy tag (supplied with the solenoid body service kit) over it.
    G08412479
  8. Download a new solenoid body strategy to the PCM. Refer to SOLENOID BODY STRATEGY DOWNLOAD .
scientia non olet · About LEMON Manuals