LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 219 (Automatic Transmission - 6F50/6F55) >> Diagnosis And Testing >> Automatic Transmission >> Diagnostic Routines >> Pinpoint Test G >> Normal Operation and Fault Conditions

Normal Operation and Fault Conditions

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

The TFT  sensor is located in the transmission solenoid body. The resistance value of the TFT  sensor varies with temperature change. The PCM monitors the voltage drop across the TFT  sensor to determine the temperature of the transmission fluid. When the ignition is turned to the RUN position, the PCM uses this initial input signal to determine whether a cold start shift schedule is necessary. The cold start shift schedule allows delayed shifts when the transmission fluid is cold. The PCM inhibits TCC  operation at low transmission fluid temperatures and adjusts line pressure to temperature.

DTC FAULT TRIGGER CONDITIONS

DTC Description Fault Trigger Conditions
P0710 TFT  sensor circuit fault TFT  sensor circuit shorted to ground or open.
P0711 TFT  sensor circuit range/performance TFT  sensor indicates a valid temperature but has not changed since start up.
P0712 TFT  sensor circuit low fault TFT  sensor circuit short to ground.
P0713 TFT  sensor circuit high fault TFT  sensor circuit open.
P1711 TFT  sensor out of self-test range TFT  sensor indicates too hot or too cold and must indicate a normal temperature range during KOER  .
P1783 TFT  sensor over temperature The TFT  sensor indicates that the transmission is approaching an overheating condition.