LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 219 (Automatic Transmission - 6F50/6F55) >> Diagnosis And Testing >> Automatic Transmission >> Component Tests >> TCC System

TCC System

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

For TCC  operation, REFER to HYDRAULIC SYSTEM .

TORQUE CONVERTER CLUTCH DESCRIPTION

Condition Possible Sources Action
  • TCC  does not apply
  • Solenoid body filter blocked to the TCC  solenoid
 
  • TCC  solenoid mechanically stuck OFF
 
  • TCC  regulator apply valve stuck OFF
  • DISASSEMBLE, CLEAN and INSPECT the TCC  regulator apply valve. If bore or valve is damaged, INSTALL a new main control. REFER to MAIN CONTROL - OVERHAUL .
 
  • TCC  control valve stuck OFF
  • DISASSEMBLE and INSPECT the TCC  control valve for debris/blockage. CLEAN as necessary. REFER to MAIN CONTROL - OVERHAUL .
 
  • TCC APPLY hydraulic circuit blocked or leaking
 
  • TCC  friction material worn or damaged
  • INSTALL a new torque converter. REFER to TRANSAXLE .
  • TCC  always applied/stalls vehicle
  • TCC  solenoid mechanically stuck ON
 
  • TCC  regulator apply valve stuck ON
  • DISASSEMBLE, CLEAN and INSPECT the TCC  regulator apply valve. If bore or valve is damaged, INSTALL a new main control. REFER to MAIN CONTROL - OVERHAUL .
 
  • TCC  control valve stuck ON
  • DISASSEMBLE, CLEAN and INSPECT the TCC  control valve. If bore or valve is damaged, INSTALL a new main control. REFER to MAIN CONTROL - OVERHAUL .
 
  • TCC RELEASE hydraulic circuit blocked or leaking
 
  • TCC  welded or damaged
  • INSTALL a new torque converter. REFER to TRANSAXLE .
  • TCC  cycles, shudders or chatters
  • Incorrect Solenoid Body Strategy programmed into TCM 
 
  • Solenoid filter or seal damaged at TCC  solenoid
 
  • TCC  solenoid mechanically sticking
 
  • TCC  regulator apply valve, springs, clips - loose, stuck, binding, missing, misassembled
  • DISASSEMBLE, CLEAN and INSPECT the TCC  regulator apply valve. If bore or valve is damaged, INSTALL a new main control. REFER to MAIN CONTROL - OVERHAUL .
 
  • TCC  control valve, springs, clips - loose, stuck, binding, missing, misassembled
DISASSEMBLE and INSPECT the main control for debris/blockage. CLEAN as necessary. REFER to MAIN CONTROL - OVERHAUL .
  TCC RELEASE/TCC APPLY hydraulic circuits blocked or leaking DISASSEMBLE and INSPECT the transmission, main control for debris/blockage. REFER to MAIN CONTROL - OVERHAUL  and CLEAN as necessary. REFER to HYDRAULIC SYSTEM .