LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Engine Mechanical - 2.0L GTDI) >> In-Vehicle Repair >> Valve Seals >> Removal

Valve Seals: Removal

WARNING: This page is about a different car, the 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan can cause engine failure.
  1. Remove the valve spring. For additional information, refer to VALVE SPRINGS  .
  2. Remove and discard the valve seal.
    1. Position the Valve Stem Oil Seal Remover and Slide Hammer over the seal.
    2. Pull up on the Slide Hammer and Valve Stem Oil Seal Remover and remove the seal.
      G08028647
scientia non olet · About LEMON Manuals