LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Engine Mechanical - 2.0L GTDI) >> In-Vehicle Repair >> Camshaft Phaser and Sprocket >> Removal

Camshaft Phaser and Sprocket: Removal

WARNING: This page is about a different car, the 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan can cause engine failure.
  1. Remove the timing drive components. For additional information, refer to TIMING DRIVE COMPONENTS .
  2. Remove the 2 bolts and the intake and exhaust camshaft phaser and sprockets.
    G08028633
  3. NOTE: Washers are not required for installation of the VCT  units.

    If equipped, discard the washers.

    G08028634
scientia non olet · About LEMON Manuals