LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Engine Mechanical - 2.0L GTDI) >> Disassembly And Assembly Of Subassemblies >> Cylinder Head >> Assembly

Cylinder Head: Assembly

WARNING: This page is about a different car, the 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: If installing the original valves, make sure the valves are installed in the same position from which they were removed.

    Coat the valve stems with clean engine oil and install the valves.

    G08028857
  2. NOTE: Lubricate the valve seal with clean engine oil prior to installing.

    Using the Valve Stem Oil Seal Installer, install the valve seal.

    G08028648
  3. NOTE: Check the seating of the valve collet.

    Install the valve spring and the valve spring retainer.

    • Compress the valve spring and install the valve collet using some grease and a small screwdriver.
      G08028855
  4. Install a new CHT  sensor.
    • Tighten to 11 Nm (97 lb-in).
      G08028854
  5. Inspect the gasket and replace if necessary.
    G08028862
  6. Install the gasket, coolant outlet and the 3 bolts.
    • Tighten to 10 Nm (89 lb-in).
      G08028853
  7. NOTE: RH shown in illustration, LH similar.

    Install the LH and RH engine lift eyes and the 2 bolts.

    • Tighten to 47 Nm (35 lb-ft).
      G08028852
scientia non olet · About LEMON Manuals