LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 216 (Engine Mechanical - 3.7L) >> In-Vehicle Repair >> Engine Mount >> Installation

Engine Mount: Installation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine mount and the 3 bolts.
    • Tighten to 90 Nm (66 lb-ft).
      G09291976
  2. Install the 4 engine mount nuts.
    • Tighten to 63 Nm (46 lb-ft).
      G09291975
  3. Install the engine mount brace, nut and bolt.
    • Tighten to 20 Nm (177 lb-in).
      Fig 1: Locating Nut, Bolt And Engine Mount Brace
      G09291974Courtesy of FORD MOTOR CO.
  4. Position the engine coolant degas bottle and install the 3 bolts.
    • Tighten to 9 Nm (80 lb-in).
  5. Install the engine appearance cover. For additional information, refer to ENGINE APPEARANCE COVER - EXPLODED VIEW  .
scientia non olet · About LEMON Manuals