LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 215 (Engine Mechanical - 3.5L) >> In-Vehicle Repair >> Engine Mount >> Installation

Engine Mount: Installation

WARNING: This page is about a different car, the 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine mount and the 3 bolts.
    • Tighten to 90 Nm (66 lb-ft).
      G09291976
  2. Install the 4 engine mount nuts.
    • Tighten to 63 Nm (46 lb-ft).
      G09291975
  3. Install the engine mount brace, nut and bolt.
    • Tighten to 20 Nm (177 lb-in).
      Fig 1: Locating Nut, Bolt And Engine Mount Brace
      G09291974Courtesy of FORD MOTOR CO.
  4. Position the engine coolant degas bottle and install the 3 bolts.
    • Tighten to 9 Nm (80 lb-in).
  5. Install the engine appearance cover. For additional information, refer to ENGINE APPEARANCE COVER - EXPLODED VIEW  .
scientia non olet · About LEMON Manuals