LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 207 (OEM Connector Repair Procedures) >> Connector Repair Procedures >> Broken Wire Strands In Harness

Broken Wire Strands In Harness

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Wiring harness tape
  2. Wring strand
  3. Broken strands intermittent signal
  4. Circuit insulation

Remove the tape and flex/feel each circuit for a reduction in diameter at break.

Fig 1: Identifying Broken Wire Strands In Harness
G09219523Courtesy of FORD MOTOR CO.