Removal and Installation
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to
JACKING & LIFTING
.
- Remove the parking brake cable equalizer adjustment nut and disconnect the front parking brake cable from the equalizer.
- Remove the LH front seat. For additional information, refer to
SEAT SYSTEM - SEATS
.
- Remove the LH front door scuff plate. For additional information, refer to
INTERIOR TRIM AND ORNAMENTATION
.
- Remove the parking brake control adjustment nut.
- Remove the front parking brake cable-to-control nut and remove the front parking brake cable from the control
.
- To install, tighten to 23 Nm (17 lb-ft).
- Remove the front parking brake cable bracket bolt
.
- To install, tighten to 23 Nm (17 lb-ft).
- Remove the 2 front parking brake cable floor plate bolts
.
- To install, tighten to 23 Nm (17 lb-ft).
- Remove the front parking brake cable.
- To install, reverse the removal procedure.