Pinpoint Test Bf: U3003:17

BF1 CHECK VOLTAGE AT THE BATTERY

Start the vehicle (Ready indicator light ON).
Turn off the headlamps, blower and any other accessories.

Measure:

Positive Lead	Measurement/Action	Negative Lead
		Ground

Is the voltage less than 16 volts?

Yes : GO to BF2
No : DIAGNOSE the over voltage condition.
REFER to: DIRECT CURRENT/DIRECT CURRENT (DC/DC) CONVERTER CONTROL MODULE - HYBRID ELECTRIC VEHICLE (HEV) .

BF2 RECHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) U3003:17
- Ignition OFF.
- Ignition ON.
- Using a diagnostic scan tool, clear the continuous memory DTCs.
- Carry out the IPC self-test.
Is DTC U3003:17 present?
- Yes : INSTALL a new IPC .
  REFER to: INSTRUMENT PANEL CLUSTER (IPC) .
- No : The system is operating correctly at this time. The DTC may have been set previously during battery charging or while jump starting the vehicle.