Pinpoint Test BD: U045A:82

BD1 VERIFY THE CUSTOMER CONCERN
- Ignition ON.
- Verify there is an observable symptom present.
Is an observable symptom present?
- Yes : GO to BD2
- No : The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
BD2 CHECK THE COMMUNICATION NETWORK
- Using a diagnostic scan tool, perform the network test.
Does the Parking Aid Module (PAM) pass the network test?
- Yes : GO to BD3
- No : REFER to: COMMUNICATIONS NETWORK .
BD3 PERFORM THE RECORDED PARKING AID MODULE (PAM) SELF-TEST
- Using a diagnostic scan tool, perform the Parking Aid Module (PAM) self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
- Yes : REFER to: PARKING AID .
  REFER to: PARKING AID - WITH ACTIVE PARK ASSIST .
- No : GO to BD4
BD4 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST
- Using a diagnostic scan tool, perform the IPC self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
- Yes : REFER to DTC CHART: IPC .
- No : GO to BD5
BD5 RECHECK THE IPC (INSTRUMENT PANEL CLUSTER) DIAGNOSTIC TROUBLE CODES (DTCS)
NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during the Programmable Module Installation (PMI), or the Programmable Module Installation (PMI) may not have been carried out.
- Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs).
- Wait 10 seconds.
- Repeat the IPC self-test.
Is DTC U045A:82 still present?
- Yes : INSTALL a new Parking Aid Module (PAM).
  REFER to: PARKING ASSIST CONTROL MODULE (PAM) . CLEAR the DTC . REPEAT the self-test. If DTC U045A:82 still present, INSTALL a new IPC .
  
  REFER to: INSTRUMENT PANEL CLUSTER (IPC) .
- No : The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.