Pinpoint Test As: The Turn Signal-Hazard On Chime Is Inoperative

AS1 CHECK THE SAFETY BELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Monitor the safety belt warning chime when the ignition is transitioned from OFF to RUN for 6 seconds.
Does the safety belt warning chime operate for approximately 6 seconds?
- Yes : GO to AS2
- No : INSTALL a new IPC .
  REFER to: INSTRUMENT PANEL CLUSTER (IPC) .
AS2 CHECK THE TURN SIGNAL INDICATOR OPERATION
- Verify the RH and LH turn signal indicators operate correctly.
Do the turn signal indicators operate correctly?
- Yes : GO to AS3
- No : GO to PINPOINT TEST K
AS3 PERFORM THE BCM (BODY CONTROL MODULE) SELF-TEST
- Using a diagnostic scan tool, perform the BCM self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
- Yes : REFER to: BODY CONTROL MODULE (BCM) .
- No : INSTALL a new IPC .
  REFER to: INSTRUMENT PANEL CLUSTER (IPC) .