Pinpoint Test B: All DIMMABLE Illumination Does Not Dim
NOTE:
Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.
- B1 CHECK THE EXTERIOR LIGHTING
- Ignition OFF.
- Observe the exterior lighting components.
- Are any exterior lighting components illuminated?
- Yes : REFER to EXTERIOR LIGHTING .
- No : GO to B2.
- B2 CHECK THE HEADLAMP SWITCH OUTPUT CIRCUIT FOR A SHORT TO VOLTAGE
- Disconnect: Headlamp Switch C205.
- Ignition ON.
- Do the dimmable backlighted components continue to illuminate?
- Yes : REPAIR the dimmable lighting output circuit for a short to voltage. TEST the system for normal operation.
- No : INSTALL a new headlamp switch. REFER to EXTERIOR LIGHTING . TEST the system for normal operation.