Glass, Frames and Mechanisms: Notes

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: This service information only applies to vehicles without one-touch up windows. Vehicles equipped with one-touch up windows can be identified by the presence an AUTO position on the RH front window control switch. For vehicles equipped with one-touch up windows, REFER to GLASS, FRAMES AND MECHANISMS - WITH WINDOW ONE-TOUCH UP .

NOTE: The accessory delay feature will allow power window operation up to 10 minutes after the ignition is off or until a door is opened.

The glass, frames and mechanisms system consists of the following:

Door window glass
Door window glass run
Door window regulator and motor
HVAC module
Power/manual sliding glass panel (if equipped)
Power sliding window motor and regulator assembly (if equipped)
Rear window glass assembly
Window control switch
Windshield glass

If equipped with power windows, the window control switch:

will operate the power windows when the ignition switch is in the RUN or ACC position, or the delayed accessory feature is active.
is located on each front door trim panel and Crew Cab rear door trim panel.
may be used to raise or lower the driver side, passenger side and rear windows from the LH front window control switch, or an individual window from the corresponding window control switch located in the door trim panel.
includes a one-touch down feature for the LH front window.
can proportionally lower the LH front window when the LH front window control switch is pressed to the 1st detent.
will automatically lower the LH front window control switch when the LH front window control switch is momentarily pressed to the 2nd detent.
will allow only the driver to operate the power windows when the LH front window control lockout switch is in the LOCK position (if equipped).