LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Taurus SEL, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1954 (Instrument Cluster Illumination And Panel Illumination -- F250-F550 Super Duty) >> Diagnosis And Testing >> Instrument Cluster and Panel Illumination >> DTC Charts

DTC Charts

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
STEERING COLUMN CONTROL MODULE (SCCM) DTC CHART

DTC Description Action
B1124:09 Lamp Fade Control: Component Failure GO to PINPOINT TEST A .
All other DTCs - REFER to the Diagnostic Trouble Code (DTC) Chart in MULTIFUNCTION ELECTRONIC MODULES .
BODY CONTROL MODULE (BCM) DTC CHART

DTC Description Action
B1314:11 White Lighting (Reflective Controls) Illumination Output: Circuit Short to Ground DIAGNOSE all other DTCs and symptoms first. If no other DTCs or symptoms are present, INSPECT the BCM and C2280B for bent pins, loose or corroded connections. If no concerns are found, INSTALL a new BCM. REFER to MULTIFUNCTION ELECTRONIC MODULES . TEST the system for normal operation.
B1315:11 Backlighting (Non Reflective Controls) Illumination Output: Circuit Short Ground GO to PINPOINT TEST B .
B1315:15 Backlighting (Non Reflective Controls) Illumination Output: Circuit Short Battery or Open If the backlighting components are inoperative, GO to PINPOINT TEST B . If the backlighting components are always on, GO to PINPOINT TEST C .
U1000:00 Solid State Driver Protection Activated - Driver Disabled: No Sub Type Information The module has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The BCM cannot enable the output until the cause of the short is corrected. ADDRESS all other DTCs first. After the cause of the concern is corrected, CLEAR the DTCs. REPEAT the self-test.
U3000:49 Control Module: Internal Electrical Failure The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the BCM can withstand. The cause of the excessive current draw MUST be corrected before a new BCM is installed. ADDRESS all other DTCs first. After the cause of the concern is corrected, INSTALL a new BCM. REFER to MULTIFUNCTION ELECTRONIC MODULES . TEST the system for normal operation.
All other DTCs - REFER to the Diagnostic Trouble Code (DTC) Chart in MULTIFUNCTION ELECTRONIC MODULES .
scientia non olet · About LEMON Manuals