LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Taurus Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1871 (Engine Mechanical - 6.8L (3V) -- F450 & F550 Super Duty) >> Removal And Installation >> Disassembly And Assembly Of Subassemblies >> Piston >> Disassembly

Disassembly And Assembly Of Subassemblies: Piston: Disassembly

WARNING: This page is about a different car, the 2012 Ford F550 Super Duty and 2012 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Since the retainer ring has a tendency to spring out, cover the end of the pin bore with a hand or shop rag when removing the ring. Wear eye protection. Failure to follow these instructions may result in serious personal injury.
  1. Remove the piston rings from the piston.
    • Discard the piston rings.
  2. Mark the piston and connecting rod on the same side for assembly reference.
    Fig 1: Locating Mark On Piston And Connecting Rod
    G06139080Courtesy of FORD MOTOR CO.
  3. Remove the 2 piston pin retainers and the piston pin.
  4. Separate the piston from the connecting rod.
  5. Clean and inspect the piston and connecting rod. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION .
scientia non olet · About LEMON Manuals