LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Taurus Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1871 (Engine Mechanical - 6.8L (3V) -- F450 & F550 Super Duty) >> In-Vehicle Repair >> Valve Cover - LH >> Installation

Valve Cover - LH: Installation

WARNING: This page is about a different car, the 2012 Ford F550 Super Duty and 2012 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: If the valve cover is not secured within 4 minutes, the sealant must be removed and the sealing area cleaned with silicone gasket remover and metal surface prep. Follow the directions on the packaging. Allow to dry until there is no sign of wetness, or 4 minutes, whichever is longer. Failure to follow this procedure may cause future oil leakage.
    Fig 1: Locating Sealant Applying Places Where Engine Front Cover Meets Cylinder Head
    G06773259Courtesy of FORD MOTOR CO.
  1. Apply a bead of silicone gasket and sealant in 2 places where the engine front cover meets the cylinder head.
  2. Position the LH valve cover and new gasket on the cylinder head and tighten the 17 fasteners in the sequence shown in illustration.
    • Tighten to 10 Nm (89 lb-in).
    Fig 2: Identifying Valve Cover Fasteners Tightening Sequence
    G06773258Courtesy of FORD MOTOR CO.
  3. Position the engine wiring harness and connect the harness retainers onto the valve cover studs.
  4. Position the PCV tube and connect the quick connect couplings. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION - GASOLINE AND DIESEL .
  5. Install the LH ignition coils. For additional information, refer to ENGINE IGNITION - 6.8L (3V) .
  6. Install the oil level indicator and tube. For additional information, refer to Oil Level Indicator and Tube .
  7. Install the ACL outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
scientia non olet · About LEMON Manuals