LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Taurus Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1871 (Engine Mechanical - 6.8L (3V) -- F450 & F550 Super Duty) >> In-Vehicle Repair >> Oil Level Indicator and Tube >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford F550 Super Duty and 2012 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the front oil level indicator and tube bolt.
    • To install, tighten to 25 Nm (18 lb-ft).
  3. Remove the rear oil level indicator and tube bolt.
    • To install, tighten to 10 Nm (89 lb-in).
  4. Remove the oil level indicator and tube from the cylinder block.
    • Discard the O-ring seal.
    5. NOTE: Lubricate the new oil level indicator tube O-ring seal with clean engine oil prior to installation.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals