LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Taurus Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1871 (Engine Mechanical - 6.8L (3V) -- F450 & F550 Super Duty) >> In-Vehicle Repair >> Oil Cooler >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford F550 Super Duty and 2012 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Drain the engine cooling system. For additional information, refer to ENGINE COOLING - GASOLINE ENGINES .
  3. Remove and discard the oil filter.
    • To install, tighten to 16 Nm (142 lb-in).
  4. Disconnect the oil cooler coolant hoses and position aside.
    5. NOTE: If metal foreign material is present in the oil cooler, mechanical concerns exist. To diagnose mechanical concerns, refer to ENGINE SYSTEM - GENERAL INFORMATION . If the mechanical concern is not diagnosed and repaired, engine failure may occur.
  5. Remove the threaded insert and the engine oil cooler.
    • Inspect the oil cooler.
    • To install, tighten to 58 Nm (43 lb-ft).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals