LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Taurus Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1871 (Engine Mechanical - 6.8L (3V) -- F450 & F550 Super Duty) >> In-Vehicle Repair >> Hydraulic Lash Adjuster >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford F550 Super Duty and 2012 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the camshafts. For additional information, refer to Camshaft - RH  or Camshaft - LH .
  2. Remove the remaining roller followers from the cylinder head being serviced.
    3. NOTE: If the components are to be reinstalled, they must be installed in their original locations, or engine damage may occur. Mark the components for installation into their original locations.
  3. Remove the hydraulic lash adjusters that are being serviced.
  4. Inspect the hydraulic lash adjusters. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION .
    5. NOTE: Lubricate each of the hydraulic lash adjusters with clean engine oil prior to installation.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals