Crankshaft Pulley: Installation
WARNING: This page is about a different car, the 2012 Ford F550 Super Duty and 2012 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
- Apply silicone gasket and sealant to the Woodruff key slot in the crankshaft pulley.
- Using the Crankshaft Vibration Damper Installer, install the crankshaft pulley.
- Using a new crankshaft pulley bolt, install the bolt and washer and tighten the bolt in 4 stages.
- Stage 1: Tighten to 90 Nm (66 lb-ft).
- Stage 2: Loosen 360 degrees.
- Stage 3: Tighten to 50 Nm (37 lb-ft).
- Stage 4: Tighten an additional 90 degrees.
- Rotate the tensioner clockwise and install the accessory drive belt.
- Rotate the lower cooling fan shroud downward until the position retainer tabs lock into position.
- Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure following the on-screen instructions.
NOTE:
If not secured within 4 minutes, the sealant must be removed and the sealing area cleaned with silicone gasket remover and metal surface prep. Follow the directions on the packaging. Allow to dry until there is no sign of wetness, or 4 minutes, whichever is longer. Failure to follow this procedure may cause future oil leakage.
NOTE:
Lubricate the crankshaft front seal inner lip with clean engine oil prior to installing the crankshaft pulley.