Removal and Installation
WARNING: This page is about a different car, the 2012 Ford F550 Super Duty and 2012 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
All vehicles
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Disconnect the Fuel Pump Control Module (FPCM) electrical connector.
Pickup and Chassis Cab with Midship Fuel Tank
- Remove the 2 nuts, stud plate and the FPCM.
- To install, tighten to 10 Nm (89 lb-in).
Chassis Cab with Aft of Axle Fuel Tank
- Remove the 2 bolts and the FPCM.
- To install, tighten to 8Nm (71 lb-in).
All vehicles
- To install, reverse the removal procedure.
NOTE:
Do not overtighten the fasteners or damage to the module may occur.
NOTE:
Do not overtighten the fasteners or damage to the module may occur.