LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Boss 302 >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (Engine Cooling - Gasoline Engines -- F250-F550 Super Duty) >> Diagnosis And Testing >> Engine Cooling >> Component Tests >> Fan Clutch Test - Minimum Speed Requirement

Fan Clutch Test - Minimum Speed Requirement

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Use a suitable marker to mark the coolant pump pulley and one of the fan blades.
  2. Make sure the A/C is OFF, if equipped.
    3. WARNING: Do not operate the engine with the hood open until the fan blade has been examined for possible cracks and separation. A damaged fan can separate during operation. Failure to follow this instruction may result in serious personal injury.
  3. Start the engine and run it at approximately 2, 000 rpm for 5 minutes or until there is a noticeable reduction in fan noise to allow the fan clutch to go into disengaged mode.
  4. Aim a laser photo tachometer at the coolant pump pulley. Run the engine to achieve 3, 000 rpm at the coolant pump or fan pulley.
  5. With the coolant pump pulley at 3, 000 rpm, aim the laser photo tachometer at the fan blade. Monitor and record fan speed.
  6. The fan blade speed must be less than the specified rpm at 3, 000 rpm coolant pump pulley rpm. Refer to the Specifications  table for correct fan speed.
  7. Turn the engine OFF.
  8. If the fan blade speed was greater than specified, install a new fan clutch.
scientia non olet · About LEMON Manuals