LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Boss 302 >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Information Center - Instrumentation, Message Center, And Warning Chimes -- F250-F550 Super Duty) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test AR: The Compass Is Inaccurate (Without Navigation) >> Pinpoint Test Ar: The Compass Is Inaccurate (Without Navigation)

Pinpoint Test Ar: The Compass Is Inaccurate (Without Navigation)

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. AR1 CHECK THE AUTO-DIMMING MIRROR POSITION 
      NOTE: When correctly positioned, the electrical connector is on the lower portion of the mirror.
    • Check to make sure the auto-dimming mirror is correctly positioned (not upside down).
    • Is the auto-dimming mirror correctly positioned? 
    • Yes  : GO to AR2.
    • No  : REPOSITION the auto-dimming mirror with the electrical connector on the lower portion of the mirror. TEST the system for normal operation.
  2. AR2 CHECK THE COMPASS ACCURACY 
    • Position the vehicle and observe the compass display as follows:
      Direction Compass Display
      North N
      Northeast NE
      East E
      Southeast SE
      South S
      Southwest SW
      West W
      Northwest NW
    • Does the compass display as indicated? 
    • Yes  : The compass is operating correctly at this time.
    • No  : GO to AR3.
  3. AR3 CHECK THE COMPASS ZONE SETTING AND CALIBRATION 
    • Yes  : The compass is OK. The concern may have been cause by an incorrect zone setting or calibration concern.
    • No  : INSTALL a new auto-dimming interior mirror. REFER to REAR VIEW MIRRORS . REPEAT the self-test. CLEAR the DTCs.

      SET the zone. REFER to COMPASS ZONE ADJUSTMENT . CALIBRATE the compass. REFER to COMPASS CALIBRATION . TEST the system for normal operation.