LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Boss 302 >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Rear Suspension -- F250-F550 Super Duty) >> Removal And Installation >> Spring - F-250, F-350 >> Removal

Spring - F-250, F-350: Removal

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Suspension fasteners are critical components because they affect performance of vital components and systems and their failure can result in major service expense. Install new components with the same component number or an equivalent component if installation is necessary. Do not use an installation component of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these components.
  1. Remove the wheel and tire. For additional information, refer to WHEELS AND TIRES .
  2. Using a suitable jack, support the rear axle.
  3. Remove and discard the U-bolt nuts and U-bolts and remove the rear spring bottom cap.
  4. Remove and discard the spring-to-front bracket bolt and nut.
  5. Remove and discard the shackle-to-rear bracket bolt and flagnut.
    6. NOTE: If the rear spring has an auxiliary spring and spacer, it is serviced as part of the rear spring assembly.
  6. Remove the rear spring assembly.
scientia non olet · About LEMON Manuals