Power Roof Opening Panel Initialization
WARNING: This page is about a different car, the 2016 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
Initialization
WARNING:
Keep objects and body parts clear of the glass panel when carrying out the initialization procedure. During the initialization procedure, the glass panel closes with high force and cannot detect objects in its path. Failure to follow this instruction may result in serious personal injury.
NOTE:
The roof opening panel motor must be initialized when repairs are carried out on the roof opening panel system, including: any time the roof opening panel motor has been removed, the roof opening panel glass (fixed panoramic or front sliding) has been removed or adjusted, or if the roof opening panel frame has been removed.
NOTE:
Carrying out the initialization will initialize both the roof opening panel glass motor and the shield (sunshade) motor.
- 2.
With the driver's door closed, place the ignition switch ON and wait for the overhead console lights to turn off.
NOTE:
Steps 3 - 4 must be performed within 3 seconds.
NOTE:
Steps 3 - 5 are to set up the overhead console to accept roof opening panel switch inputs to be held for up to a maximum of 150 seconds. Normally, the overhead console will consider the switch stuck after 30 seconds and ignore those longer inputs from the switch.
- 4.
Without pausing, press and release the right map light switch four times ending with the lamp off.
- 6.
Press and hold the sliding glass close switch within 10 seconds until the shield moves to the fully closed position and then to the fully open position, then release the switch and immediately begin step 7.- The sliding glass will move to the hard stop (after approximately 10 seconds), stall and then move back to the closed position.
- Then the shield will move forward to the hard stop, stall and then retract to the fully open position.