Pinpoint Test B: All Power Windows Are Inoperative

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.

B1 CHECK VOLTAGE TO LH FRONT WINDOW CONTROL SWITCH
- Disconnect: LH Front Window Control Switch C566B (Crew Cab) or C537 (regular and SuperCab).
- Ignition ON.
- Measure the voltage between LH front window control switch and ground.
  - For regular and SuperCab, measure the voltage between LH front window control switch C537-3, circuit CBP32 (GN/VT), harness side and ground.
  - For Crew Cab, measure the voltage between LH front window control switch C566B-3, circuit CBP01 (BU), harness side and ground.
    
    Fig 1: Measuring Voltage Between LH Front Window Control Switch C566B-3, Circuit CBP01 (BU), Harness Side And Ground
    Courtesy of FORD MOTOR CO.
- Is the voltage greater than 10 volts?
- Yes : INSTALL a new LH front window control switch. REFER to WINDOW CONTROL SWITCH . TEST the system for normal operation.
- No : VERIFY BCM fuse 32 (15A) (regular and SuperCab) or circuit breaker 48 (30A) (Crew Cab) is OK. If OK, GO to PINPOINT TEST F to diagnose the accessory delay circuit.
  If not OK, REFER to the appropriate SYSTEM WIRING DIAGRAMS to identify the possible causes of the circuit short. TEST the system for normal operation.