LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Electronic Engine Controls - Diesel Engine -- F250-F550 Super Duty) >> Removal And Installation >> Powertrain Control Module (PCM) >> Removal

Powertrain Control Module (PCM): Removal

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls or the vehicle may be damaged.
  1. Turn the ignition switch to the OFF position.
  2. Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to MODULE CONFIGURATION .
  3. Disconnect the RH battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  4. Detach the wiring harness retainer.
  5. Disconnect the PCM electrical connectors.
  6. Remove the 2 nuts and the PCM bracket.
    • Remove the PCM.
scientia non olet · About LEMON Manuals