Throttle Position (TP) Sensor - 6.8L (3V): Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: When installing the new TP sensor, make sure that the radial locator tab on the TP sensor is aligned with the radial locator hole on the ETB.

NOTE: Do not use power tools.

Install the new TP sensor.
- Using hand tools, install the 2 new bolts.
  - Tighten to 3 Nm (27 lb-in).
    
    Fig 1: Locating TP Sensor With Bolts
    Courtesy of FORD MOTOR CO.
Connect the TP sensor electrical connector.

Fig 2: Locating Throttle Position (TP) Sensor Electrical Connector
Courtesy of FORD MOTOR CO.
Install the ACL outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .