LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (Electronic Engine Controls - Gasoline Engine -- F250-F550 Super Duty) >> Removal And Installation >> Mass Air Flow (MAF) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the Mass Air Flow (MAF) sensor electrical connector.
  2. Remove the 2 bolts and the MAF sensor.
    • To install, tighten to 2 Nm (18 lb-in).
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals