Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Left side shown in illustration, right side similar.

NOTE: Fender-molding is one-time-use only.

Remove the 5 rear fender wheel molding retainers.

NOTE: Before installing the new rear fender wheel molding, clean the rear fender wheel molding mounting area with an appropriate cleaner.

Make sure all the old pressure sensitive tape is removed from the rear fender molding mounting area.

NOTE: After installation apply 7-11 kg (15-25 lbf) of pressure with a roller along the entire perimeter, including the bottom underwrap normal to the surface.

To install, reverse the removal procedure.