LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Glow Plug System - 6.7L Diesel -- F250-F550 Super Duty) >> Removal And Installation >> Glow Plug >> Installation

Glow Plug: Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the glow plug.
    • Tighten to 11 Nm (97 lb-in).
  2. Pull the glow plug electrical connector out of the outer sleeve.
    Fig 1: Pulling Glow Plug Electrical Connector Out Of Outer Sleeve
    G07481895Courtesy of FORD MOTOR CO.
  3. Connect the glow plug electrical connector to the glow plug and push the connector down to lock the connector on the glow plug.
  4. Position the RH or LH engine sound shield and install the 5 RH or 4 LH engine sound shield retainers.
  5. Install the LH or RH fender splash shield. For additional information, refer to FRONT END BODY PANELS .
scientia non olet · About LEMON Manuals