LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (HVAC - Climate Control System -- F250-F550 Super Duty) >> Removal And Installation >> In-Vehicle Temperature Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument cluster finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
  2. Remove the instrument panel lower support bracket cover bolt and remove the support bracket cover.
  3. Remove the 3 instrument panel lower support bracket bolts and the support bracket.
    • To install, tighten to 9 Nm (80 lb-in).
      Fig 1: Identifying Instrument Panel Lower Support Bracket And Bolts
      G07486070Courtesy of FORD MOTOR CO.
  4. Disconnect the in-vehicle temperature sensor aspirator hose connection.
  5. Detach the in-vehicle temperature sensor aspirator hose pin-type retainer.
  6. Disconnect the in-vehicle temperature sensor electrical connector.
  7. Remove the in-vehicle temperature sensor and aspirator hose as an assembly.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals